ARC Raiders - macros for bloody, x7 - Pack 2

Macros – No Recoil for Bloody & x7 mice in ARC Raiders remove most of the vertical recoil for the ANVIL, ARPEGGIO, BURLETTA, RENEGADE, IL TORO significantly improving accuracy and thereby increasing the effective range against opponents. Your mouse Bloody must be activated and supported by the BLOODY 7 software.

Macros with the .mgn extension are closed for editing — they can only be used and are not compatible with the Bloody WorkShop 8 program.

Macros with the .amc extension are for X7 mice, and they can be imported into the Bloody Workshop 8 software.


The macros was designed for mouse sensitivity settings in the game ranging from 50, FOV 80, Mouse Zoom Sensitivity Multiplier - 100%, from 100fps and above.

ANVIL: level 4, No attachments.

ARPEGGIO: level 1 and 4, Magazine Size - 36, No attachments.

BURLETTA: level 1...4, Magazine Size - 22, No attachments.

RENEGADE: level 1, Magazine Size - 12, No attachments.

IL TORO : level 4, No attachments.

If your aiming in the game is toggled by a single right-mouse-button click, then use macro versions:

v1.0, v5.0

If your aiming works by holding the right mouse button, then use macro versions:

v5.4 and v5.5. After enabling these macros, recoil control will activate when both the right and left mouse buttons are held down. If the right button is not pressed, the left button works normally.


v1.0.amc and v5.0…amc — Load these macros onto the mouse button F (7th) if your mouse has it, or onto button 3 (wheel click) and side buttons 5 and 4.
After pressing the macro button once, recoil control (or another assigned action) will start.


v5.0…mgn and v5.4…mgn — These macros are loaded onto the top mouse buttons N and 3, located behind the scroll wheel.
After pressing the macro button, it activates, and recoil control will work when pressing the left mouse button (for v5.0…mgn).
For v5.4…mgn, recoil control will work when both right and left mouse buttons are held down. If the right button is not pressed, the left button works normally.
To disable the macro, press the 1 button located next to the N button.


ARC_Raiders-SLIDE_RUN-v1.0.amc — Slide running. Press and hold the macro button to initiate slide running. Releasing the button will stop the slide run.

ARC_Raiders-ROLL_JUMP-v1.0.amc — Roll jump. After a single press of the macro button, the character will perform a forward jump with a roll.

ARC_Raiders-BOLT-v1.0.amc and M-ARC_Raiders-BOLT-v5.5.mgn — For weapons that require manual bolt cycling.


VIDEO: soon

If your in-game mouse sensitivity settings are either too high or too low for you, you can adjust your mouse´s DPI, which won´t affect the macros performance.